Do-It-Yourself Office, Quality Issues

Cleaning the Scanner on HP Laser Printers;4000/4050

4000 scannerLaserJet-4000/4050 Scanner 
This article shows how to clean the scanner on the Hewlett Packard 4000 series Laser Printers.

This procedure needs to be done when the machine is in a dirty environment and the dust builds up on the mirror inside the scanner. Toner seems to be drifting into the scanner on the HP LJ-4250 printers more often lately. I have had five machines in one week do this. It may be bad toner cartridges? Some people have told me to use a Q-tip and reach up through the scanner slit area, but I don’t see how you could do an accurate job, so I have outlined the procedure the way that I do it.

Tools needed:
#2 Phillips head screw driver, Needle nose pliers, and small flat blade screw driver, Q-tip.

Estimated Time of repair:
60 minutes first time 30 minutes subsequent

Symptoms of a dirty scanner:
Light prints even after you have tried a new toner cartridge. Mostly shows itself as light prints on one side of prints or streaks or wide blank lines. HP LJ-4250: Blank streak down the middle of page. Note:This procedure is basically the same for the Following LaserJet Models:
4000, 4050, 4100, 4200, 4300, 4250, 4350

Getting to the Scanner:Turn the power off and remove the power cord. Remove the right rear side cover. Push the cover toward the rear and it will slide out. Open the top cover and remove the toner cartridge. Remove the toner cartridge drive arm. Remove the Toner Cartridge Drive Arm by using needle-nose pliers to pinch the pin from its hinge on the Top Cover. Remove the four screws holding the Top Cover (two are behind the Rear Output Bin, near the top, and two are on top of the printer under the Top Cover). Squeeze the right front side of the Top Cover to remove it. It may be necessary to use a small flat-blade screwdriver to release the tab inside the small hole. Holding the output assembly in place (located toward the rear of the printer), remove the Top Cover. Disconnect the wiring connector(s).

Remove output assembly:
Facing the rear, pull up brass arm on the left side straight up. Pry the white tab on the right side and pull the output assembly up and out. Caution: Be careful of the sensor flag. When reinstalling make sure it rotates freely.

Removing the Scanner Cover:
Carefully remove the wiring connectors. Remove the cover of the scanner by removing the screws and using a small flat blade screwdriver to release the latches. Carefully remove the cover.

Cleaning the Mirror:
The only mirror you will be cleaning is the one that shines directly on to the drum in the toner cartridge. This mirror is at an angle. You need to clean the mirror from below. Use a Q-tip to clean it. Make sure you clean the edges really good. Reinstall everything in reverse order.


2 thoughts on “Cleaning the Scanner on HP Laser Printers;4000/4050

  1. Thanks i just solved that problem today…i tried changing the toner catrige and drum several times but couldnt improve not until now..thanks once again.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s