Copiers, Fuser, printers

5 Things that Cause Fuser Jams

My printer/copier/fax machine is jamming in the exit.  Jamming in the exit or fuser assembly can be caused by five things.

fuser rollers

1.) Bad separation fingers ; These can also be called Separation Claws, Scrapers and Pick off Pawls.  The fingers are small ceramic claws that ride against the upper roller.   They are normally spring  loaded. When these go bad it will do an accordion type of jam.  They could be worn , broken or out of position.  There  is normally a spring on them for pressure to the upper heat roller.

2.) Bad heat rollers; The teflon coating will wear off and the paper will stick and cause jamming

3.) Brocken gear(s); If the gear is broken the paper can’t get through.

4.) Sensor or sensor lever flag; This should be the last thing you check, uncommon fault.  Test with simulations , multi meter or replace with known good sensor.

5.) Dirty Fuser entrance guide;  This will cause wrinkling, creases in paper and  jamming.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s